WorldPay

Configure WorldPay in Sana Admin

When the WorldPay payment provider is installed and configured in the WorldPay merchant interface it should be also configured in Sana Admin.

 To configure WorldPay:
 
Step 1: In Sana Admin click: Setup > Ordering & checkout > Payment methods > Configuration > WorldPay Payment.

Step 2: Configure the necessary settings.
 
The table below provides the description of the WorldPay payment provider settings.

Field	Description
Installation_Id	Enter the installation ID. It is available on the 'Installation Administration' page in the WorldPay merchant interface.
MD5_Secret	Enter the MD5 secret. It should be the same as the value of the MD5 secret for transactions field on the 'Installation Administration' page in the WorldPay merchant interface.
SignatureFields	The 'SignatureFields' parameter tells the WorldPay payment service, which values to use when checking your MD5 signature. It consists of the 'amount', 'currency', 'cartId' and 'instId' parameters. The value of this field should be the same as in the 'SignatureFields' field on the 'Installation Administration' page in the WorldPay merchant interface.
Callback_PassWord	This value should match the value of the 'Payment Response password' field on the 'Installation Administration' page in the WorldPay merchant interface.
Merchant_Code	This parameter specifies which merchant code should receive funds for this payment.

When WorldPay is installed and configured you can set up the necessary payment methods in Sana Admin that are supported by WorldPay.